Monday, June 20, 2011
eWON News, [ Industrial Remote access ]
Plug'n Route
No need for Gateway address in remote devices on the local LAN with Plug'n Route.
Plug'n Route is a new routing feature inside the eWON running firmware 6.2s0 or higher.
It highly simplifies the configuration steps to access Ethernet devices through Talk2M.
When Plug'n Route is activated, then there is no no need anymore to reprogram the Ethernet device to define the eWON LAN as default gateway.
With Plug'n Route, once the VPN tunnel to the eWON through Talk2M established, you can use the local IP address of the Ethernet device to connect to it. As if you where connected locally.
The Plug'n Route feature is activated by default by the Talk2M wizard.
The Plug'n Route feature can be enabled/disabled using menu System Setup/ Configuration/ Networking Config/ Routing:
![]()
Plug’n Route
No need for Gateway address in remote devices on the local LAN with Plug'n Route.
Plug'n Route is a new routing feature inside the eWON running firmware 6.2s0 or higher.
It highly simplifies the configuration steps to access Ethernet devices through Talk2M.
When Plug'n Route is activated, then there is no no need anymore to reprogram the Ethernet device to define the eWON LAN as default gateway.
With Plug'n Route, once the VPN tunnel to the eWON through Talk2M established, you can use the local IP address of the Ethernet device to connect to it. As if you where connected locally.
The Plug'n Route feature is activated by default by the Talk2M wizard.
The Plug'n Route feature can be enabled/disabled using menu System Setup/ Configuration/ Networking Config/ Routing:
Wednesday, June 15, 2011
Subscribe to:
Posts (Atom)